During the "New Horizons in Global Steel Markets" 11th Annual Conference organized by SteelOrbis in Istanbul on November 17, Osman Sever, general secretary of Turkey’s Automotive Manufacturers Association, stated that Turkey is exporting 76 percent of its automotive production, while the Asia Pacific and Middle Eastern markets are attractive.
Remarking that automotive industry output has increased in western Europe and North America while global automotive production is expected to increase by three percent year on year in 2016, Mr. Sever said commercial vehicle production has increased more than automobile production in the world. In Turkey, the situation is the opposite, with commercial vehicle production decreasing this year, with a 50 percent decline in heavy vehicle output.
Mr. Sever said that overall auto sales in western Europe, which is Turkish automotive exporters’ most important market, increased by 9.6 percent in the first half of this year and this has been very important for Turkish exporters. Meanwhile, in 2016 Turkey’s automotive output is expected to be over 1,450,000, and currently Turkey’s share of global automotive production is 1.56 percent, while its record share so far reached 1.61 percent. This year, Turkey’s automotive exports are expected to exceed 1 million units. Depending on these positive market conditions, "2016 will be the next best year for Turkish automotive industry" said Mr. Sever.
For 2017, Mr. Sever said that Turkey’s automotive exports will be at higher levels with the new projects which will start late this year. With the addition of these new projects to current ones, the Turkish automotive industry is expected to reach full capacity and exports will increase by a figure approaching 10 percent. However, it is still uncertain whether Brexit will negatively impact Turkey’s auto exports and this is why the forecast is only for an increase above five percent but less than a double digit figure, according to Mr. Sever.
Mr. Sever added that the Turkish automotive industry needs the domestic steel sector to produce hot rolled coil (HRC) in widths of over 1,500 mm and to give lead times of a week instead of lead times of a month.