US domestic HDG prices inch higher as scrap prices drop

Tuesday, 12 February 2013 02:04:37 (GMT+3)   |   San Diego

Just as prices in the coated flat steel spot market have finally inched up, US domestic scrap prices settled lower for February, creating added uncertainty over whether prices could rise further. Following flats mills' price increases a few weeks ago, even though purchasing activity picked up, many of the immediate orders were at pre-increase levels. However, over the last week, sources tell SteelOrbis that mills have been insistent on higher prices, although spots are still about $1.50-$2.00 cwt. ($33-$44/mt or $30-$40/nt) lower than official asking prices.

While many generally agree that the deepest market discounts are now almost entirely unavailable, there is little confidence that this past week's upward move is likely to continue. Service center sources noted that because they have been unable to raise resale prices to match mill price increases, the increases aren't gaining the necessary support to fuel an upward trend. Further, scrap falling about $10-$15/lt in most parts of the US this month has only added to the general reluctance to take possession of any hot dipped galvanized (HDG) or Galvalume coil that isn't immediately necessary.

  Cwt. Metric Ton (mt) Net ton (nt) Change from last week
US domestic HDG base price $35.00-$36.00 $772-$794 $700-$720 ↑$1.00 cwt. on low end
         
0.012"x40.875" G30        
ex-Midwest mill $45.00-$46.00 $992-$1,014 $900-$920 ↑$1.00 cwt. on low end
         
0.019"x48" G90        
ex-Midwest mill $45.00-$46.00 $992-$1,014 $900-$920 ↑$1.00 cwt. on low end
         
US domestic Galvalume base price         
ex-Midwest mill $35.00-$36.00 $772-$794 $700-$720 ↑$1.00 cwt. on low end
         
0.019x41.5625 Gr80/AZ55        
ex-Midwest mill $45.00-$46.00 $992-$1,014 $900-$920 ↑$1.00 cwt. on low end

Marketplace Offers

HDG Coil

Thickness 0.5 - 4 mm
Width 1,000 - 1,500 mm
Coil  R
 
Tedarikçi DAVUTOĞLU METAL MAK. İNŞ. SAN. TİC. LTD ŞTİ.
View Offer

Prepainted Coil

Thickness 0.4 mm
Width 1,000 mm
Coil  R
  9002
Tedarikçi OZGUN METAL
View Offer

Prepainted Coil

Thickness 0.4 mm
Width 1,200 mm
Coil  R
  9002
Tedarikçi OZGUN METAL
View Offer

Similar articles

Import concerns grow prevalent in US HDG market

US import HDG buyers unwilling to pay higher prices

Import pressure looms on the horizon for US domestic HDG market

US import HDG price direction continues to point higher

Conservative purchases keep US domestic HDG prices stable

US HDG market could be on shaky ground

US import HDG price trend varied by product

US HDG prices stable but uncertain

Offshore mills holding firm on import HDG offers to the US

US domestic HDG market at a crossroads